The 95th (Rifle) Regiment of Foot
Development of the Sword Bayonet
With fixed swords, members of the 2nd Btn 95th Rifles (Australia)
form square
with the 42nd and 73rd Regiments at Old Sydney Town, Easter 1999.
The 95th (Rifle) Regiment of Foot
Development of the Sword Bayonet
With fixed swords, members of the 2nd Btn 95th Rifles (Australia)
form square
with the 42nd and 73rd Regiments at Old Sydney Town, Easter 1999.
| Early bayonets for the Baker rifle
were designed as short swords. It follows that bayonets in the 95th Rifles
would be termed "swords", and the regular infantry command of
"fix bayonets" was changed for riflemen to "fix swords".
Between 1800 and 1837, there were four differing patterns of bayonets issued for the Baker rifle. The first, known as "Pattern 1800" was a sword bayonet with a flat blade of 23 inches long, one and one quarter inches wide by one quarter inch thick at the hilt. It was double-edged for about six inches at the spear shaped point. The hilt measured four and one quarter inches and had a squared off corner where the knucklebow met the crossguard. A cord hole was drilled through the pommel. The knucklebow had weak points at the extremities, causing its obsolescence the following year.
The second "Pattern 1801" sword bayonet had the same blade, but with the double-edged section of the point only five inches long. The hilt used the same locking method as the first pattern, but its overall construction was much stronger. Slightly longer in hilt at four and a half inches, the weak squared knucklebow was replaced with a rounded, more robust D shaped knucklebow.
The above early pattern long sword-bayonets, when fixed to the short Baker rifle, gave an overall length close to that of the Brown Bess and bayonet. This presented a uniform wall of steel, when riflemen joined other regiments in square, to receive a cavalry charge. A totally revised pattern was introduced in 1815. This third model, or "Pattern 1815" was a conventional triangular bladed socket bayonet. Its blade was only 17 inches long, it was hollow ground on two edges, being flat on the third edge. This bayonet could only be fitted to altered rifles. Although approved earlier in 1815, they were not delivered to riflemen until after Waterloo.
In 1823 a revised bayonet was approved. Known as the "First Pattern Hand Bayonet", it consisted of the triangular blade combined to a second pattern sword hilt, but without the knucklebow. The final change for Baker rifle bayonets came two years later, when a "Second Pattern Hand Bayonet" appeared. It was similar to the 1823 Hand Bayonet, but with a smaller and lighter hilt.
|
Copyright © 2000
|
|||||||||||||||||||||
